SECTION 2
INSTALLATION
Figure
Gas Burner
Manifold Pressure Tap
Figure
G.Maintenance
It is recommended to check yearly the minimum and the maximum setting and readjust them if necessary.
H.Connection
WARNING
Some procedures in this section may require conversions, readjustments, or service on the oven's gas system. Before performing these procedures, check that the main= gas supply valve and the circuit breaker/fused disconnect are in the OFF ("O") position. After completing these procedures, perform a
gas leak test before operating the oven.
CAUTION
The terms of the oven's warranty require all
Main Orifices
Gas Burner
Assembly
Manifold Pressure Tap
Gas Valve
NOTE: Certain safety code requirements exist for the installation of gas ovens; refer to the beginning of Section 2 for a list of the installation standards. In addition:
• In the USA, the installation must conform with local codes, |
or in the absence of local codes, with the National Fuel |
Gas Code, ANSI Z223.1. |
• In Canada, the installation must conform with local codes, |
or in the absence of local codes, with the Natural Gas |
Installation Code, |
Installation Code, |
• InAustralia, the installation must conform withAGACodes |
AG311 and AG601, and with any requirements of the |
appropriate statutory authority. |
• In CE countries, the gas supply connection should be |
according to |
applicable ISO |
Figure
Adjustment Screw (5 mm) | Adjustment |
for minimum pressure | Screw (8 mm) for |
setting | maximum |
| pressure |
| setting |
F.Checkout
After any adjustment, set appliance in operation and observe through a component cycle to ensure that burner system components function correctly.
| aspects of the gas supply connection must comply with |
| current IEC/CEE requirements and with all applicable |
| local, national, and international codes. |
• | For all ovens equipped with casters, the gas line connection |
| shall be made with: |
-A connector that complies with the Standard for Connectors for Movable GasAppliances,ANSI Z21.69 (in USA), or Connectors for Movable GasAppliances,
Check the oven’s gas supply requirements to determine the type of gas to be used with the oven. If the gas type required does NOT match the local supply:
•For North American installations, a conversion kit is supplied with the oven to allow operation using propane gas. Refer to Part B, Gas Conversion, in this section.
•For CE ovens, directions for converting the oven for use with other gases are described in Part D.1, Preparation for Use with Various Gases, in this section.
16