![Installing the appliance(s)](/images/new-backgrounds/65758/6575871x1.webp)
Installing the appliance(s)
Feed the connection cable down through the
Starting at the front, position the appliance in the worktop
Using both hands, press down evenly on the sides of the appliance until it clicks into position. When doing this make sure that the seal under the appliance sits flush with the worktop on all sides. This is important to ensure an effective seal all round. Do not use sealant.
When installing several appliances, a sealing strip must be fitted into each spacer bar.
Push the appliance to the side until the long slots in the spacer bar can be seen.
Fit the sealing strip d into the long slots in the spacer bar b.
Starting at the front, position the next appliance in the worktop
Connect each appliance to the mains (see "Electrical connection").
Check that each appliance works correctly.
Once installed, the hob can be removed using a special tool.
It can also be pushed up out of the
36