Before using for the first time
To programme the water hardness level
Each time a button is pressed one of the indicator lights will flash and light up in the control panel. However, only the indicator lights mentioned in the following programming process stages are significant.
The programming procedure can be cancelled at any time by pressing the On/Off button s. The procedure can then be
^Switch the dishwasher off with the On/Off button s.
^Press the Start/Stop button in and whilst holding it in switch the dishwasher on using the On/Off button s.
Keep the Start/Stop button pressed in for at least four seconds until the "Start/Stop" indicator light comes on.
If this does not happen, start the procedure from the beginning again.
^Press the Delay start button twice.
The "Delay start" indicator will flash briefly twice at intervals.
The characters "p 1 5" will flash one after the other in the display.
This means that the water hardness level has been set at 15 °d (2.7 mmol/l) (factory setting).
The value which has been set for the water hardness is shown as a figure after the "p" in the display (see chart).
^Use the Start/Stop button to select the value which equates to your water hardness level.
Each press on the button moves you up a level. When the highest water hardness level is reached, the setting starts from the beginning again.
^Switch the dishwasher off with the On/Off button s.
14
