Problem solving guide
The dishwasher does not fill/drain
Problem | Possible cause | Remedy | |
The Inlet/Drain | The stopcock is | Open the stopcock fully. | |
check indicator | closed. |
| |
flashes. |
|
| |
The dishwasher |
| Before rectifying the problem | |
stops during a |
| you must: | |
programme. |
| – Switch the dishwasher off with | |
The Inlet/Drain |
| the On/Off button s. | |
check indicator | Fault F12/F13: | – Open the stopcock fully. | |
flashes. | |||
Water inlet restricted. | – Clean the water inlet filter (see | ||
Fault code FXX | |||
| "Problem solving"). | ||
shows in the display. |
| ||
| – The water pressure at the | ||
|
| ||
|
| intake is lower than 30 kPa | |
|
| (0.3 bar). | |
|
| Seek professional advice. | |
| Fault F11: | – Clean the filter combination. | |
| Water outlet is | See "Cleaning and Care". | |
| restricted, water | – Clean the drain pump. See | |
| remains in the wash | "Problem solving". | |
| cabinet at the end of a | – Clean the | |
| programme. | See "Problem solving". | |
|
| ||
|
| – Remove any kink in the drain | |
|
| hose. |
46