Installation
Install the bracket on the rear of the custom door panel
^Make sure the dishwasher is level.
^Measure the distance X between the round hole in the machine outer door panel (shown in inset) and the lower edge of the adjoining cabinet door.
^Place the door panel on a flat surface, good side face down, being careful not to scratch the surface. Make certain that the bottom of the panel is towards you.
^Using a pencil, lightly draw a vertical centerline on the panel (See illustration on the next page).
^Draw a horizontal line X inches up from the bottom edge of the panel.
For two piece panels:
Two piece panels should be made so that any joining hardware is flush with the back of the panel . Failure to do this may impede proper operation of the dishwasher.
In certain instances, you may be able to use the mounting bracket supplied with the machine to secure both pieces to the dishwasher.
Consult your cabinet supplier / maker for the best method of joining the panels.
When mounting the two pieces, make sure that the desired finished panel height is maintained.
19
