Installation
7.Adjust and secure the front panel
Once installed, the panel can be raised
or lowered up to 1/16" (2 mm) to match the cabinet lines.
Adjust one side of the door panel at a time using a T20 Torx screwdriver.
Do not use a power screwdriver to adjust or secure the decorative panel to the dishwasher.
^If the upper screws on the edge of the door are not loose, loosen them slightly.
^The panel can be raised or lowered by turning the lower screw on each side of the dishwasher door.
To raise the panel turn clockwise. To lower the panel turn counterclockwise.
^Once this side of the panel lines up with the cabinets, secure it by tightening the upper screw on the edge of the dishwasher door.
^Repeat the process with the other side of the panel.
^Close the door.
^Check the alignment. Readjust if needed.
^Insert the supplied end caps into the four screw holes.
22
