Miele KF 7540 SN installation instructions Changing over the door handle, Refitting the doors

Changing the door hinging

^Pull bearing bush d downwards out of hinge bracket e and refit it from above into the hinge bracket.

^Use a screwdriver to remove spacer g and refit it on the opposite side.

Changing over the door handle:

^Remove covers m at the front and slide off to the side.

^Unscrew handle k. Refit handle and stoppers l on the opposite side.

^Slide covers m into position making sure they engage correctly.

Refitting the doors:

^Remove plugs j from door bearing bushes in the doors and refit on the opposite side.

^Hang the upper appliance door on hinge pin c, and close the appliance door.

^Push middle hinge pin f from below through hinge bracket e into the upper appliance door.

^Check that the door is correctly aligned. If necessary align it using the long slots in hinge bracket e.

^Hang the lower door in hinge bracket e then close the appliance door.

In the following illustration the lower door is not shown in the closed position to make it easier to see what happens next.

^Turn door support b around, pull hinge pin a out, and refit on the opposite side.

^Fit both parts into hinge plate f. To do this push hinge pin a through hinge plate f into door support b. Swing door support out, push upwards and re-assemble with screw c.

^Align the lower door with the appliance housing using the long slot in hinge plate f. Then tighten screw c.

^Refit plinth fascia d pushing it firmly into position.

^With the lower door open, secure cover e to the front of the plinth fascia.

42