Installation
Safety instructions for installation
Fit wall units and extractor hood before fitting the hob to avoid damaging the surface.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C
Any backmoulds must be of
This equipment may only be used in mobile installations such as
ships, caravans, aircraft etc. if a risk assessment has been carried out by a suitably qualified engineer.
The hob may not be built in over a fridge, fridge freezer, freezer,
dishwasher, washing machine or tumble dryer.
These hobs must not be installed above ovens or cookers unless
these have a
After installing the hob, ensure that the connection cable cannot come
into contact with the underside of the appliance. Make sure that there is no mechanical obstruction, such as a drawer, which could damage it.
If a protective shelf is installed under the
be a minimum distance of 190 mm between it and the top of the worktop to allow for ventilation to the appliance. A gap of 10 mm is required at the back for feeding the electrical cable through.
Observe carefully the safety distances given on the following
pages.
Do not use any sealant except where expressly instructed to do
so. The seal underneath the appliance provides a sufficient seal for the worktop (see "Sealant").
All dimensions in this instruction booklet are given in mm.
43
