Installation
Securing an alternative anti-tip device
If the
Ensure that there is no "give" between the appliance and the
If possible, always screw the wooden beam to existing studs.
^Cut a wooden beam (cross section min. 3" x 4"
[75 cm x 100 cm]) to the required length.
The length is equal to the width of the installation niche.
–If the installation cavity is deeper than the appliance, select a beam which has a larger cross section, or attach two beams.
–The beam must cover the appliance by at least 2" (50.8 mm).
^Mark the installation height (lower edge of the beam) on the rear wall of the niche.
^Select screws according to the thickness of the wooden beam. Example: 3 ½" (89 mm) screw for 2x4 beam.
^Determine the number of screws based on the cavity width, to ensure that the beam will be attached securely.
^Locate wall studs near the rear wall of the cavity and mark drill holes in the beam.
^
^Attach the wooden beam to the rear wall of the niche.
If a
47
