Operating modes

Operating modes

M 626 EC, M 636 EC

The 7 operating modes detailed below are available.

M 616 EG, M 626 EG, M 636 EG

Here you can choose between 3 opera- ting modes, Microwave Solo, Grill and a combination of these two, see 1, 4, and 7 below; (Fan Heat and Fan Grill- ing (with or without microwave mode) are not available).

1. Microwave-Solo mode ü Suitable for defrosting, reheating or cooking.

2. Fan Heat D* Ideal for baking.

3. Fan Grilling I*

Use to grill or roast thicker cuts of meat and pieces of poultry. The fan and the grill heating element operate at the same time.

4. Grilling J

Ideal for grilling thinner items e.g. steaks or sausages.

5. Combination mode - Microwave

üwith Fan Heat D*

You can use this combination mode to prepare puddings very quickly.

6. Combination mode - Microwave

üwith Fan Grilling I*

This combination is particularly suit- able for roasting and grilling.

7. Combination mode - Microwave üwith Grilling J

Ideal for crisping and browning. The microwave cooks the food, the grill browns and crisps the surface.

*only with models M 626 EC and M 636 EC

Automatic programmes

The Automatic Defrosting programme

Noffers 4 programmes (d1 – d4).

The Automatic Cooking programme Q offers 8 programmes (C1 – C8). All the automatic programmes are weight dependent, which means that the weight of the food must be entered. The automatic programmes for defrost- ing and cooking can also be set to run one after the other.

Short step system

Touchpads 1, 2, 3 allow you to store in the memory programmes you use fre- quently. Each memory store can be used again with a different programme.

Delaying start

(only on models M 626 EC and M 636 EC)

The length of cooking time and the end of a process can be pre-programmed up to 24 hours beforehand.

Automatic "Keeping warm"

The automatic "keeping warm" function will switch on for a maximum of 15 minutes after a cooking process using a power setting of 5 or higher has fin- ished.

18

Page 18
Image 18
Miele manual Operating modes, M 626 EC, M 636 EC, M 616 EG, M 626 EG, M 636 EG, Automatic programmes, Short step system