Installation
Installation site
,Make sure the dryer door can be opened without hindrance after installation.
Transporting the machine to its installation site
When moving the machine you can hold it by the lid where it protrudes to the rear of the dryer.
To manoeuvre the dryer out of its packing case to its installation site you will also need to hold it by the front feet.
Building under a continous worktop / in a row of kitchen units
The dryer should not be installed next to a refrigerator or freezer. The warm air expelled from the rear of the dryer would increase the temperature around the refrigerator's/freezer's heat exchanger causing the compressor to run continuously.
If it is not possible to install the dryer anywhere else, then the refrigerator/freezer must be sealed off from the dryer.
A building under kit* is required which must be fitted by a suitably qualified person.
The machine lid is replaced by a coverplate. It is essential that the coverplate is fitted to ensure electrical safety.
–When installing under a 900/910 mm high worktop a spacer kit* is required.
–The electrical socket must be located in an accessible position near the machine.
*Available as an optional accessory from your Miele dealer or the Miele Spare Parts Department.
The building under kit is supplied with its own installation instructions.
N.B. When built under running times may be longer.
If you wish to push your machine under a worktop and there is space to do this without removing the lid, the building under kit is not necessary. Otherwise the building under kit is essential.
Replacing the lid
If the lid has been removed in order to fit a cover plate, ensure that, if the lid is replaced, it fits securely into the rear holders. Otherwise, it is not properly secure for transport.
36
