Rear view
aProtruding lid for holding when
moving the appliance (see arrows)
bMains connection cable
cVenting connection at the rear
Installation site
,Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the appliance to its
installation site
When moving the appliance, hold it by
the lid where it protrudes to the rear of
the dryer. To manoeuvre the dryer out
of its packing case to its installation site
hold it by the front feet and at the
back of the lid.
Building under a continous worktop /
in a kitchen run
,Abuilding-under kit* with a
coverplate to replace the appliance
lid is required. It must be fitted by
suitably qualified person to ensure
electrical safety.
N.B. If you wish to push your appliance
under a worktop and there is space to
do this without removing the lid the
building-under kit is not necessary.
Otherwise it is essential.
– The building-under kit is supplied
with its own installation instructions.
– N.B. When built under drying times
may be longer.
– The electrical socket must be
located in an accessible position
near the appliance.
– The space required by the vent duct
must be taken into consideration
when calculating the distance
between the tumble dryer and a wall
or other appliances or furniture on
either side.
With niche heights of:
–830-840 mm, longer screw feet* are
required.
–870-885 / 915-930 mm, one or two
raising kits* are required.
* Miele accessory available to order
Replacing the lid
If the lid has been removed in order to
fit a coverplate, ensure that, if the lid is
ever replaced, it fits securely into the
rear holders. Otherwise, it is not
properly secure for transport.
Installation and connection37