Activating the icompartment
This function should be activated if
traditional "big box" detergents are
used. For the first 10 seconds of the
main wash cycle water flows in
through compartment i.
Compartment j may sometimes not
be able to hold the total amount of
detergent required when:
- the water is very hard (over 3.8 mmol/l,
water hardness level IV) and
- the washing is heavily soiled.
In this case compartment i can be
used to flush in the extra detergent for
the main wash.
Before the "Activating the i compart-
ment" programmable function can be
selected you must first select pro-
gramming mode.
Selecting programming mode
1The machine must be switched off
and the drum door closed. The pro-
gramme selector must point to "Fin-
ish".
2Press the additional option buttons
"Short" and "Water plus" at the same
time and hold pressed in and:
3. . . switch the machine on with the
“I-ON/0-OFF”-button.
4Let go of all these buttons.
The indicator light "Main wash" flashes
in the sequence display.
Selecting the programmable function
To select the "Activating the i com-
partment" programmable function turn
the programme selector to – Spin ***.
Activating
To activate "Activating the i compart-
ment" press the "START" button once.
The "Rinses" light comes on in the se-
quence display.
Storing in memory
To store the "Activating the i compart-
ment" programmable function in the
memory SWITCH the machine OFF with
the “I-On/0-OFF" button.
The "Activating the i compartment"
programmable function is now stored in
the machine’s memory.
Deactivating
To deactivate the use of Compartment
i repeat the procedure given above
from point 1 as far as the *** shown
above. Press the START button and the
"Rinses" indicator light will go out. The
function is deactivated. Store in mem-
ory by pressing the I-On/0-Off button.
Programmable functions
33