Whattodo,if... Cause... Remedy.... . .the “Check(water) inlet"
indicatorflashes during the
programmebut the pro-
grammeis running normally.
The water inlet is restricted. –The stopcock is not opened
far enough.
–The inlet hose is kinked.
–The water pressure is too low
–The filter in the inlet hose is
dirty. Clean it.
. . .the “Check(water) inlet"
indicatorflashes and the
laundrywas not washed.
The water inlet is closed. –Open the stopcock.
–Start the programme again.
. . .one of the following indi-
catorlights is flashing
– “Soak/Pre-wash”
–“MainWash”
– “Rinses”
– “Rinse hold”
There is a fault. –Press “I-ON/0-OFF” button to
release it.
–Turn the programme selector
to "Finish".
–Press “I-ON/0-OFF” button in.
–Re-start the programme.
–If the indicator light starts
flashing again, call the
Service Dept.
Problem solving guide
44