Optionally Connect to Backplane (continued)
THROUGH FIBER UPLINK
To connect fiber cable from
1.Locate
2.Locate or build
TX | TX | TX | RX |
RX | RX | RX | TX |
3.Connect male TX and RX cable connectors at one end of cable to TX and RX female connectors, respectively, on
4.Connect male TX and RX cable connectors at other end of cable to RX and TX connectors, respectively, on 802.3 compliant
5.Set SWITCH 1 (located on the
SWITCH | (UP) Enables the LinkALERT™ function. (DOWN) | ||||
1 | 2 |
| Enables standard Link Integrity Test. Default is | ||
|
|
|
|
| |
|
|
|
|
| LinkALERT™ enabled (UP). |
|
|
|
|
| NOTE: SWITCH 2 is not used. |
|
|
|
|
| |
|
|
|
|
| |
NOTE: The LinkAlert™ feature allows each port to pass network link faults over the port link. If the port does not detect a good link on one side, the port disables all transmission (including
| LINK FAULT INDICATION |
|
Device | Port | Device |
LINK FAULT INDICATION
Optionally Cascade E-FL-0x00 Hubs
To cascade hubs by installing fiber cables between hubs:
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
1.Locate or build
TX | TX | TX | RX |
RX | RX | RX | TX |
2.Connect male TX and RX cable connectors at one end of cable to TX and RX female connectors, respectively, on front of one hub.
3.Connect male TX and RX cable connectors at other end of cable to RX and TX connectors, respectively, on front of second hub.
Connect E-FL-0x00 Hub to Terminal Devices using Fiber
To connect fiber cable from
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
1.Locate or build
TX | TX | TX | RX |
RX | RX | RX | TX |
2.Connect male TX and RX cable connectors at one end of cable to TX and RX female connectors, respectively, on
3.Connect male TX and RX cable connectors at other end of cable to RX and TX connectors, respectively, on 802.3 compliant fiber device.
4.Repeat steps
