3-2. Installing Fenders And Lights
WARNING
TILTING OF TRAILER can result in personal injury or equipment damage.
• Use adequate blocks or lifting device to support hitch end while pivoting trailer jack into position (see Section
•Use trailer jack to obtain desired height and to support tongue weight while installing fenders and lights.
rwarn1.1* 3/93
1 | 9 | 8 | 7 |
6
2
3
5
10 11
4
Disconnect from vehicle wiring harness before beginning installation.
| To Vehicle | To Trailer | Brown | Green |
|
Right Stop/ |
|
| Lead | Lead | Tools Needed: |
|
|
| RIGHT |
| |
Signal Lamps |
| Sidelight |
|
| |
(Green) | Short Leads |
|
|
| |
Left Stop/ |
|
|
|
| 9/32 in |
Signal Lamps |
|
|
|
|
|
(Yellow) |
|
|
|
| Taillights |
|
|
|
|
| |
Taillights |
|
|
|
|
|
(Brown) |
|
|
|
|
|
Ground | White (Ground) Lead |
|
| 7/16, 9/16 in | |
|
|
| LEFT | ||
(White) | Tab Connector |
|
| ||
| Brown | Yellow | 5/8 in | ||
|
| Ground Lead | |||
|
| Lead | Lead |
| |
|
| (Ground To Trailer Frame) | |||
|
|
|
| ||
|
|
|
|
| |
Support trailer with jack. Apply parking brake.
1 Fender
hardware. If hole is not present, drill a 9/32 in (7 mm) hole in side rail as shown.
taillight Stop hole. Attach taillight to bracket with 1/4 in hardware.
2 Support Bracket
Attach fenders and brackets to frame with
3Ring Terminal Lead
4Wiring Harness White Ground Lead
5Tab Connector
Splice ring terminal lead to white lead with supplied connector (see Figure
Secure ring terminal to side rail using
Route brown and green leads through clamps on right inside of frame and out end of channel.
6 Sleeving
Slip sleeving over leads. Route leads through back of right taillight bracket.
7Taillight
8Tail Hole
9Stop Hole
Insert stripped end of brown lead into Tail hole in rear of right taillight. Insert green lead into
10Sidelight
11Marker Brown Hole
Route stripped end of either supplied short lead through hole in right trailer frame chan- nel. Insert lead into top Marker Brown hole.
Splice remaining end of short lead to brown lead from wiring harness.
Secure sidelight with 10 - 24 hardware.
Install left side taillight and sidelight using wir- ing harness brown and yellow leads.
