FWD WHEELCHAIRS | PROCEDURE 8 |
Upper Limit
Switch
Bracket
Phillips
Screws,
Washers
and Lock-
nuts
Actuator
24o Back
Recline Angle
61o
Magnetic Protractor - (Will read 61o when back
recline angle is at 114o
relative to the seat
frame)
FIGURE 13 - ADJUSTING LIMIT SWITCH
114o
5o Seat Angle
F
W
D
W
H
E
E
L
C H A I R S
REMOVING/INSTALLING SHROUDS | Removing Side Shrouds and Fillers | |
(FIGURE 14) | 1. Remove the front shroud from the wheelchair. Refer | |
Removing Front Shroud | to REMOVING/INSTALLING FRONT SHROUD in | |
this procedure of the manual. | ||
|
1.Unclip the retaining strap securing the front shroud and battery box to the wheelchair.
2.Feed the retaining strap through the front shroud.
3.Remove the front shroud from the wheelchair.
Installing Front Shroud
1.Feed the retaining strap through the front shroud as shown in FIGURE 14.
2.Position the bottom of the front shroud between the battery box and the battery tray.
3.Clip the retaining strap together.
Removing Rear Shroud
1.Unclip the retaining strap securing the rear shroud and battery box to the wheelchair.
2.Feed the retaining strap through the rear shroud.
3.Remove the rear shroud from the wheelchair.
Installing Rear Shroud
1.Feed the retaining strap through the front shroud as shown in FIGURE 14.
2.Clip the retaining strap together.
3.Press down on the rear shroud until the two (2) clips secure the rear shroud to the two (2) side shrouds.
2.Remove the rear shroud from the wheelchair. Refer to REMOVING/INSTALLING REAR SHROUD in this procedure of the manual.
3.Perform one (1) of the following:
A.INTEGRATED SLING SEAT MODELS - Fold thewheelchair.RefertoTRANSPORTINGEXCEL in this procedure of the manual.
B.CAPTAIN'S SEAT MODELS - Remove the Captain's Seat from the wheelchair. Refer to REMOVING/INSTALLING CAPTAIN'S SEAT in PROCEDURE 9 of the owner's manual, part number 1080737.
4.HIGH BACK CAPTAIN'S SEAT MODEL WHEEL- CHAIRS ONLY (DETAIL "A") - Remove the phono jack nut that secures the phono jack to the side shroud.
5.Remove the phillips screws, bolts, washers and lock- nuts that secure side shroud and filler to the wheel- chair frame. Refer to FIGURE 14 for phillips screw and washer locations.
6.Remove side shroud and filler from the wheelchair.
7.Repeat STEPS
27
