REINSTALLING THE PAN/TILT COVER
The pan/tilt covers must be properly seated and have a tight seal all the way around when installed.
NOT SEALED |
|
INCORRECT | CORRECT |
|
GAP
Figure 9. Installing the Pan/Tilt Cover
To reinstall the pan/tilt cover, do the following:
1.Properly position the cover and slide it into place. The sides of the cover must fit under the front and back rain guards of the pan/tilt, and the top of the cover must seat against the lip of the top gasket.
2.Apply pressure and push the top of the cover down to align the fastener holes.
3.Insert the Phillips screw and tighten. Tighten until the screw will not turn.
TOP GASKET
FRONT
RAIN
GUARD
Figure 10. Fastening the Pan/Tilt Cover
13 |