DIRECTION LINE
MAIN MENU |
|
| Other Menu |
|
|
|
| Az/El/Direction |
| ||
<Camera> |
|
| Temp Units |
| Celsius |
|
| Set Azimuth Zero |
| ||
<Power Up Mode> |
|
| Park time minutes | 0 |
|
|
| Az/El | Left | ||
<Limit Stops> |
|
| Scan Speed deg/s | 7 |
|
|
| Az/El Line | 10 | ||
<Other> |
|
|
| Pattern Length |
| 1.5 min |
|
| Direction | Right | |
<System Information> |
|
| Spd Profile | 90 MPH Wind |
|
| Direction Line | 10 | |||
<Factory Defaults> |
|
| <Zone Blank> |
|
|
|
|
| Zoom | Center | |
Exit |
|
| <Az/El/Direction> |
|
|
|
| Zoom Line | 10 | ||
|
|
|
|
|
|
| |||||
|
|
|
| Exit |
|
|
|
|
| Disp Duration | 2 |
Exit
Direction Line controls the vertical display position of the Direction label. You can display the label on lines 3 through 10.
Line 3 is the third line from the top of the screen; line 10 is located at the bottom of the screen. The default is 10.
NOTES:
•Direction display is not available while you are programming or running a pattern.
•Use different horizontal position and line settings for Az/El, Direction, and Zoom. Otherwise, the labels may overwrite one another.
To program the vertical label position for direction:
1.Program preset 95 (28). The main menu appears.
2.Position the cursor (>) beside <Other>. Press the Iris Open button; the menu appears.
3.Position the cursor (>) beside <Az/El/Direction>. Press the Iris Open button; the menu appears.
4.Position the cursor (>) beside Direction Line. Press the Iris Open button; the cursor moves to the right.
5.Move the joystick up or down to view the available selections.
6.Do one of the following:
•Select: Press the Iris Open button to select the option.
•Cancel: Press the Iris Close button to leave the setting as is.
26 |