PATTERNS
The Esprit system can do either one full pattern (1.5, 3, or 6 minutes long) or two half patterns (0.75, 1.5, or 3 minutes long). Refer to Pattern Length on page 36 and Power Up Mode on page 37 for more information.
Patterns can include any standard pan/tilt or lens command. Presets, flip, proportional pan, and turbo are not allowed in a pattern. Zones can be enabled while running a pattern. Refer to your control system documentation to program and run patterns.
To create a pattern:
1.Access the programming mode for your controller.
2.Create the patterns using the following names:
•Long Pattern: Program PATTERN 0.
•Short Pattern: Program PATTERN 1 and PATTERN 2.
3.Program each pattern.
NOTE: When you program a long pattern, it overwrites any short patterns. When you program short patterns, they overwrite the long pattern.
After you program your patterns, you can call them or configure the unit to run them when it powers up.
PARK
If the system does not receive any commands for a specified period of time (refer to Park Time Minutes on page 35), the system goes to preset 1 and parks. If the time specified is zero, or if preset 1 has not been programmed, the pan/tilt will not park.
OPEN COLLECTOR AUXILIARY OUTPUT
An AUX 2 command from the controller will activate a device, such as a relay. The output will remain active for two seconds and then deactivate, even if the controller is set to latching mode.
One example of a device that can be used with AUX 2 is a latching relay (not supplied by Pelco) to control a gate or lights.
To use a relay from the AUX 2 output, the relay must require less than 32 VDC and 40 mA to trigger the relay coil. Also, the relay must be placed within 100 ft (30 m) of the Esprit unit.
16 |
