PATTERN LENGTH
MAIN MENU |
|
| Other Menu |
| ||
<Camera> |
|
| Temp Units |
| Celsius | |
<Power Up Mode> |
|
| Park time minutes | 0 | ||
<Limit Stops> |
|
| Scan Speed deg/s | 7 | ||
<Other> |
|
|
| Pattern Length |
| 1.5 min |
<System Information> |
|
| Spd Profile | 90 MPH Wind | ||
<Factory Defaults> |
|
| <Zone Blank> |
|
| |
Exit |
|
| <Az/El/Direction> |
| ||
|
|
|
| Exit |
|
|
The Esprit can run either of the following:
•One full pattern that is 1.5, 3, or 6 minutes long.
•Two half patterns that are 0.75, 1.5, or 3 minutes long.
This pattern can consist of any standard pan/tilt or lens command. Presets, flip, and turbo are not allowed in a pattern. Zone scan can be enabled while running a pattern. (For more information about programming patterns, refer to Patterns on page 16.)
To set the pattern length:
1.Program preset 95 (28). The main menu appears.
2.Position the cursor (>) beside <Other>. Press the Iris Open button; the menu appears.
3.Position the cursor (>) beside Pattern Length. Press the Iris Open button; the cursor moves to the right.
4.Move the joystick up or down to toggle through the number of minutes (1.5, 3, or 6).
CAUTION: If the pattern length is changed, all patterns that were stored are erased.
5.Do one of the following:
•Select: Press the Iris Open button to select the option.
•Cancel: Press the Iris Close button to leave the setting as is.
36 |
