ZONES
Basic rules for setting zones:
1.Your controller must support zone operation.
2.Refer to the documentation for your control system to program zones.
3.Establish zones using the controller, before programming ZONE BLANK with the Esprit
4.To accurately set zone areas, press Zoom Wide to zoom to the full screen.
5.Set zones moving the joystick left to right. The left position is always the start position.
ZONE BLANK
MAIN MENU |
|
| Other Menu |
|
|
| Zone Blank Menu |
| ||
<Camera> |
|
| Temp Units |
| Celsius |
| Video Blank Zone | 1 Off | ||
<Power Up Mode> |
|
| Park time minutes | 0 |
|
|
| 2 Off | ||
<Limit Stops> |
|
| Scan Speed deg/s | 7 |
|
|
| 3 Off | ||
<Other> |
|
|
| Pattern Length |
| 1.5 min |
|
| 4 Off | |
<System Information> |
|
| Spd Profile | 90 MPH Wind |
|
| 5 Off | |||
<Factory Defaults> |
|
| <Zone Blank> |
|
|
|
|
| 6 Off | |
|
| <Az/El/Direction> |
|
|
|
| ||||
Exit |
|
|
|
|
|
| 7 Off | |||
|
|
|
| Exit |
|
|
|
|
| 8 Off |
Exit
The Esprit system features
Zones can be programmed to overlap each other, although this is not recommended. If you program two zones to overlap, the title of the zone with the highest priority (zone 8 is the highest, zone 1 is the lowest) will be displayed on the monitor. This rule also applies to blanked zones that overlap. The blanking status of the zone with the highest priority will determine if the area is blanked or not.
For Example: Zone 1 is blanked but a portion of the zone overlaps zone 8 which is not blanked. The overlapped portion of zone 1 will be displayed on the monitor with the zone 8 label.
There are two video zone blank settings:
•On: Enables video blanking.
•Off: Disables video blanking.
To change the video blank zone setting:
1.Program preset 95 (28). The main menu appears.
2.Position the cursor (>) beside <Other>. Press the Iris Open button; the menu appears.
3.Position the cursor (>) beside <Zone Blank>. Press the Iris Open button; the menu appears.
4.Position the cursor (>) beside the number of the zone for which you want to set the blank option. Press the Iris Open button; the cursor moves to the right.
5.Move the joystick up or down to toggle between On and Off.
6.Do one of the following:
•Select: Press the Iris Open button to select the option.
•Cancel: Press the Iris Close button to leave the setting as is.
49 |
