Invacare P9000 service manual Users Weight 201 to 250 LBS, Rotate battery tray hanger bracket up

FWD WHEELCHAIRS PROCEDURE 8

NOTE: If motors are repositioned, the front riggings may need to be repositioned. Refer to ADJUSTING/REPLAC- ING TELESCOPING FRONT RIGGING SUPPORT in PROCEDURE 9 of the owner's manual, 1080737.

FACTORY SETTINGS

MOTOR MOUNTING POSITIONS

SEAT	16	SEAT DEPTH
WIDTH		17	18
16	MIDDLE	MIDDLE	MIDDLE
18	MIDDLE	MIDDLE	MIDDLE
20	MIDDLE	MIDDLE	MIDDLE

USERS' WEIGHT 200 LBS AND UNDER -

MOTOR MOUNTING POSITIONS

SEAT		SEAT DEPTH
WIDTH	16	17	18
16	REAR	REAR	REAR
18	REAR	REAR	REAR
20	REAR	REAR	REAR

USERS' WEIGHT 201 TO 250 LBS -

MOTOR MOUNTING POSITIONS

SEAT		SEAT DEPTH
WIDTH	16	17	18
16	MIDDLE	MIDDLE	MIDDLE
18	MIDDLE	MIDDLE	MIDDLE
20	MIDDLE	MIDDLE	MIDDLE

NOTE: The front motor mounting position is reserved for future applications.

1.Remove the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.

2.Perform one (1) of the following:

A.WHEELCHAIR EQUIPPED WITH FLIP-UP REMOVABLE FOOTBOARD - Remove the hex screws and spacers that secure the battery tray hanger bracket and footboard mounting bracket to the wheelchair frame.

B.WHEELCHAIRNOTEQUIPPEDWITHFLIP-UP REMOVABLE FOOTBOARD - Remove the front hex screw that secures the battery tray hanger bracket to the wheelchair frame.

3.Rotate battery tray hanger bracket up.

4.Left side of wheelchair only - Remove the front dust cover from the end of the crossbrace.

NOTE: Left is determined by sitting in the wheelchair.

5.Refer to charts in this procedure to determine the proper mounting position that corresponds to the user's weight.

6.Remove the six (6) socket screws that secure the motor to the wheelchair frame.

7.Position the motor on the wheelchair frame at the position noted in STEP 5 as shown in FIGURE 26.

STEPS 2, 4, 10, 11, 12 Spacers

Dust Cover (Not Shown)

Battery Tray

Hanger

Bracket

Hex Screws

Footboard

Mounting

Bracket

LONG Socket Screws (Apply Loctite 242 and

torque to 60-inch pounds) (STEPS 6, 8)

Wheelchair

Frame

SHORT
Socket Screws
(Apply Loctite
242 and
torque to 60-
inch pounds)	Motor/
(STEPS 6, 8)	Gearbox

NOTE: It is not necessary to disconnect the clutch handle from the motor/gearbox.

FRONT MOTOR

MOUNTING POSITION

MIDDLE MOTOR

MOUNTING POSITION

REAR MOTOR

MOUNTING POSITION

FIGURE 26 - REPOSITIONING MOTORS

F

W

D

W

H

E

E

L

C H A I R S

37