PROCEDURE 9

RWD WHEELCHAIRS

R

W

D

W

H

E

E

11.Reinstall dust covers onto bottom of crossbraces.

12.Reinstall the hex screws and locknuts that secure the pivot links to the wheelchair frame and crossbraces.

13.Install the new back and seat upholstery onto the wheelchair. Refer to REPLACING BACK UPHOL- STERY in PROCEDURE 3 of this manual and REPLACINGSEATUPHOLSTERYinPROCEDURE 5 of the owners manual, part number 1080737.

14.Reinstall the battery tray and battery boxes/batteries onto the wheelchair. Refer to BATTERY TRAY and INSTALLING/REMOVING BATTERY BOXES in this procedure of the manual.

L C H A I R S

Crossbrace

Locknut

Hex

ScrewHex

Screws

Wheelchair

Frame

Dust Cover

Pivot Tube

Hex Plug Pin

Screws

Washer

Pivot Link

Locknut

Note orientation of hex screw, bushing, washers, coved washers and locknut for in- stallation of new crossbraces.

FIGURE 8 - CHANGING SEAT WIDTH

ADJUSTING SEAT-TO-FLOOR HEIGHT

WARNING

Adjusting seat-to-floor height MUST be performed by Invacare Technical Support, 1-800-832-4707.

DISCONNECTING/CONNECTING MKIV CONTROLLER, MOTOR AND BATTERY LEADS (FIGURE 9)

NOTE:ToconnectMKIVcontrollermotorandbatteryleads, reverse the following procedure.

1.Disconnect the fastening straps that secure the nylon boot around the connected motor and battery leads.

2.Disconnect controller left/right motor and battery leads from the leads secured to the wheelchair with tie wrap.

Fastening Straps

Nylon Boot

Battery Lead

Leads From

Controller

Left/Right Motor

Leads

FIGURE 9 - DISCONNECTING/CONNECTING MKIV

CONTROLLER, MOTOR AND BATTERY LEADS

44

Page 44
Image 44
Invacare P9000 service manual Adjusting SEAT-TO-FLOOR Height, H a I R S