PROCEDURE 5

ELECTRONICS

E L E C T R O N I C S

This Procedure Includes the Following:

Preparing MKIV Joystick for Use

Repositioning MKIV Joystick

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.

PREPARING MKIV JOYSTICK FOR USE (FIGURE 1)

NOTE:TorepositiontheMKIVjoystickonaCaptain’sSeat, refertoREPOSITIONINGMKIVJOYSTICK-CAPTAIN’S SEAT in PROCEDURE 8 of this manual.

NOTE: The MKIV joystick is factory installed on the right side of the wheelchair. To reposition the MKIV joystick onto the left side of the wheelchair, refer to REPOSITIONING MKIV JOYSTICK in this procedure of the manual.

1.Turn the lever on the adjustment lock to release the adjustment lock from joystick mounting tube.

2.Slide joystick mounting tube to the desired position.

3.Turn the lever on the adjustment lock to secure the adjustment lock to the joystick mounting tube.

MKIV Joystick

Joystick

Mounting Tube

Adjustment

Lock

Lever

REPOSITIONING MKIV JOYSTICK (FIGURE 2)

1.Turn the lever on the adjustment lock to release the adjustment lock from joystick mounting tube (tube).

2.Remove the joystick from the wheelchair.

3.Remove the three (3) hex screws that secure joystick mounting bracket (bracket), the threaded hole half clamp and the opened hole half clamp to the arm tube.

4.Reposition the threaded hole half clamp and opened hole half clamp on the opposite arm tube. Make sure threaded hole half clamp is on the inside of arm tube.

5.While holding the two (2) half clamps, install the front hexscrewintothetwo(2)halfclamps.Securelytighten.

6.Lineupmountingholesofthejoystickmountingbracket with the mounting holes in the two (2) half clamps.

7.Secure the joystick mounting bracket to the two (2) half clamps with the remaining two (2) hex screws.

8.Slide tube through the bracket to the desired position.

9.Slide the adjustment lock over the end of the tube and secure the adjustment lock to the tube by turning the lever on the adjustment lock.

Threaded Hole

Half Clamp

Arm Tube

Joystick

Joystick Mounting

Tube

Hex Screws

Joystick Mounting Bracket

Adjustment Lock

Lever

Opened Hole Half Clamp

FIGURE 1 - PREPARING MKIV JOYSTICK

FOR USEFIGURE 2 - REPOSITIONING MKIV JOYSTICK

12

Page 12
Image 12
Invacare P9000 Preparing Mkiv Joystick for USE Figure, Repositioning Mkiv Joystick Figure, Procedure Electronics