Miller Electric 300 P manual Mounting Welding Generator

5-2. Mounting Welding Generator

Y Do not weld on base. Weld-
	ing on base can cause fuel
	tank fire or explosion. Weld
	only on the four mounting
Supporting The Unit	brackets or bolt unit down.
	Do not mount unit by sup-
Y
	porting the base only at the
	four mounting brackets.
	Use cross-supports to ade-
2	quately support unit and pre-
	vent damage to base.

Mounting Surface:

OR

1

Inadequate support.

YDo not use flexible mounts.

1

1Cross-Supports

2Mounting Brackets (Supplied)

Mount unit on flat surface or use cross-supports to support base. Secure unit with mounting brack- ets.

31/2 in Bolt And Washer (Minimum − Not Supplied)

43/8-16 x 1 in Screws (Supplied)

To Bolt Unit In Place:

Remove hardware securing the four mounting brackets to the base. Reverse brackets and reattach to base with original hardware.

Using Mounting Brackets	Mount unit to truck or trailer with 1/2
	in (12 mm) or larger hardware (not
	supplied).
	To Weld Unit In Place:
	Weld unit to truck or trailer only at
	the four mounting brackets.

2

Welding Unit In Place

Bolting Unit In Place

23

4

Tools Needed: 9/16 in

install3 8/06 803 274 / 200 864-A / 803 562

OM-4433 Page 17