Miller Electric Axcess Process Set Up Push Button, Make a selection, rotate the Adjust control

5-9. Process Set Up Push Button

3

Process

Wire Type

Gas Type

2

1

Process Set Up

1Process Set Up Push Button

2Process Set Up LED

3Program Selection LEDs

•Press the Process Set Up push button the first time will illuminate the button LED and Process LED above the button. Both displays will show the current process and, if desired, these displays will be active to allow selecting a new process. Default processes are MIG, PULSE, and ACCU PULSE.

•Pressing the Process Set Up push button a second time will illuminate the Wire Type LED and the bottom display will show wire types available for the selected process. To make a selection, rotate the Adjust control.

•Pressing the Process Set Up push button a third time will keep Wire Type LED lit, but the upper display will be active and show wire sizes available for the current wire type. To

make a selection, rotate the Adjust control.

•Pressing the Process Set Up push button a fourth time will illuminate the Gas Type LED and both displays will show available gas selections for the process, and wire type and wire size selection. To select an item, rotate the Adjust control.

•Pressing the Process Set Up push button a fifth time will load the program that matches the selected parameters (process, wire type, wire size, gas). The upper display will show PROG and the lower display will show LOAD.

If no changes were made to any setup items, no program will be loaded, and unit will return to standby mode.

If a custom program is loaded using an optional PDA with File Management software, the upper display will show CUST and the lower display will show PROG. The Adjust control remains active to allow loading a standard program in place of the custom program.

•Pressing and holding the Process Set Up push button in on power up allows viewing the software revisions of each circuit board in the system. The top display shows the board (PCM, UIM, WFCM, and AIM (auto- mated units only) and the lower display shows the last 3 digits of the circuit board part number plus a letter designator. Press the flashing Feeder Set Up push button to exit the screen displays and continue the power up process.

Table 5-1. Welding Wire And Gas Abbreviations*

Wire Description	Wire Abbreviation	Alloy Type	Gas Type	Gas Abbreviation
Steel	STL	E70, E100, E120	100% CO2,	CO2
			90% Argon/10% CO2,	C10
			85% Argon/15% CO2,	C15
			75% Argon/25% CO2,	C25
			95% Argon/5% CO2,	C5
			95% Argon /5% O2,	OX5
			98% Argon/2% O2	OX2
Stainless Steel	SS	308, 309, 312, 316	98% Argon, 2% O2	OX2
			(81Ar/18HE/1CO2	Tri Gas
			Accu-pulse)
			90HE/7-1/2Ar/2-1/2CO2	Tri Gas
			MIG/RMD/Accu-pulse)
Cored Tubular Wire	MCOR	71, 76, 86R, 409,	90% Argon/10% CO2	C10
		439
			98% Argon/2% O2	OX2
Aluminum	ALUM	4XXX, 5XXX	100% Argon	ARGN
* Not all wire types may be available with your unit.

OM-211 076 Page 21