Miller Electric Digital Elitet Replacing the Lens Covers, Outside Lens Cover, Inside Lens Cover

SECTION 5 − REPLACING THE LENS COVERS

Be sure wide edge of gasket faces helmet shell.

Be sure flat side of gasket faces helmet shell.

3

2

1

6

5

4

Ref. 805 012

! Never use the auto- darkening lens with- out the inside and out- side lens covers prop- erly installed. Welding spatter will damage the auto-darkening lens and void the warranty.

1Front Lens Gasket

2Outside Lens Cover

3Lens Assembly Gasket

4Lens Assembly

5Inside Lens Cover

6Lens Frame

Remove the lens assembly to remove either lens cover.

To remove the lens assem- bly, push down on the helmet bottom retaining arms and push the retaining clips to- ward the outside of the hel- met. Lift up on the assembly and pull free of the helmet.

Outside Lens Cover

Remove the outside lens cover by pushing cover into the helmet. Remove the rub- ber lens gasket and install on the new lens cover. Reinstall the lens assembly.

.Be sure the flat side of

lens cover gasket faces the helmet shell.

Inside Lens Cover

To replace the inside lens cover, remove the lens as- sembly from the lens frame by pushing up on the top two retaining tabs while gently pushing the lens free.

Remove the lens cover by sliding it out of either side. Replace with the new cover lens and reinstall the assem- bly in the helmet.

OM-234 388 Page 11