Miller Electric OM-1500-4 manual Trigger Hold Switch, Optional Voltage Control And Digital Meters

4-3. Trigger Hold Switch

1

1 Trigger Hold Switch

Trigger hold allows the operator to weld with- out holding the gun trigger.

		802 828-A
•	To use the trigger hold function, place the	seconds before releasing it. Welding will
	trigger hold switch in the On position.	continue when the trigger is released.
•	The operator must hold the trigger for a mini-	• To stop welding, press the trigger again.
	mum of 2 seconds, but not longer than 6

4-4. Optional Voltage Control And Digital Meters

1

2

3

1 Voltmeter

Displays actual or preset voltage from welding power source through the 14–pin control cable.

2 Wire Speed Meter

Factory set to display inches per minute. If display of meters per min- ute is desired, see Section 3-8.

3 Voltage Control

Use control to adjust voltage output of welding power source.

.You can adjust the preset volt- age display on the wire feeder to match your power source’s display by adjusting P2 on mo- tor control board PC1. See Section 5-2 for location of P2.

802 827-A

OM-1500-4 Page 17