Multiquip MC3SE, MC3H operation manual Starting the Engine Honda engine

MIX N' GO MIXER — INITIAL START-UP (GASOLINE ENGINE)

DO NOT attempt to operate the mixer until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood.

This section is intended to assist the operator with the initial start-up of the walk-behind trowel. It is extremely important that this section be read carefully before attempting to use the trowel in the field.

Starting the Engine (HONDA engine)

1.Place the engine fuel valve lever (Figure 20) to the "ON" position.

3.Place the choke lever (Figure 22) in the "OPEN " position if starting a cold engine.

Figure 20. Engine Fuel Valve Lever (ON Position)

2.Place the trowel's throttle lever (Figure 21) to the "IDLE" position.

Figure 21. Throttle Lever (Idle Position)

Figure 22. Engine Choke Lever (Open)

4.Placethe chokelever(Figure23)inthe"CLOSED"position if starting a warm engine or the temperature is warm.

Figure 23. Engine Choke Lever (Closed)

5.Place the engine ON/OFF switch (Figure 24) in the "ON " position.

Figure 24. Engine ON/OFF Switch (ON Position)

MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 23