MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 9
■
High Temperatures – Always stop engine and allow the
engine to cool before adding fuel, oil or performing service
and maintenance functions. Contact with

hot

components can
cause serious burns.
■
NEVER disconnect any
"emergency or safety devices"
.
These devices are intended for operator safety. Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
■
If mixer is equipped with an electric motor, operate

only

at
120 VAC, 60 Hz.
■
Make sure the

OFF/ON

power switch is always in the
OFF
position before inserting the mixer's power plug into an AC
receptacle (electric model only).
Maintenance Safety
■
NEVER lubricate components or attempt service on a running
machine.
■
ALWAYS allow the machine a proper amount of time to cool
before servicing.
■
Keep the machinery in proper running condition.
■
Fix damage to the machine immediately and always replace
broken parts, or missing decals.
■
Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■
DO NOT use food or plastic containers to dispose of
hazardous waste.
■
DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
RULES FOR SAFE OPERATION
■
NEVER Run engine without air cleaner. Severe engine
damage may occur.
■
ALWAYS read, understand, and follow procedures in
Operator’s Manual before attempting to operate equipment.
■
ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using roller.
■
ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■
NEVER leave the mixer unattended, turn off engine or electric
motor when unattended.
■
CAUTION must always be observed while servicing this mixer.
Rotating parts can cause injury if contacted.
■
Unauthorized equipment modifications will void all
warranties.
■
Ensure that any trailing cable is protected against damage
and not liable to be tripped over or trapped underneath the
mixer.
■
Ensure any extention cables must be no longer than 30 meters
(100 feet) in length and that the wire section is 2.5 mm 2.
■
DO NOT allow extension cord to come into contact with water
or fluids.
■
DO NOT expose power tools to

rain

or

wet

conditions.
■
This mixer is intended for the production of concrete, mortar
and plaster. Mixer must be used only for its intended purpose.
■
This mixer is not suitable for the mixing of

flammable

or

explosive

substances.
■
NEVER operate the mixer in an

explosive

atmosphere.
■
Before starting the mixer, check that all

guards

are in position
and correctly fitted.
■
DO NOT tip mixer onto drum mouth when the motor is running.
■
Keep area around the mixer

clear of obstructions

which
could cause persons to fall onto

moving parts

.
■
ALWAYS ensure mixer is on level ground before mixing.
■
Become familiar with the controls of the machine before
operating.
■
ALWAYS replace any worn or damaged warning decals.
■
Ensure the drum is

rotating

while filling and emptying the
drum.
■
DO NOT use mixer as a wheel barrel.
■
ALWAYS disconnect AC power plug from power source
before moving mixer (electric model only).