Multiquip MC3SE, MC3H operation manual MIX N GO Mixer Troubleshooting ENGINE/MIXER

MIX N' GO MIXER — TROUBLESHOOTING (ENGINE/MIXER)

TABLE 7. ENGINE TROUBLESHOOTING (Continued)

SYMPTOM	POSSIBLE PROBLEM	SOLUTION
Operation not satisfactory
	Governor adjustment improper?	Adjust governor to correct lever.
	Governor spring defective?	Clean or replace ignition.
Rotational speed fluctuates.
	Fuel flow erratic?	Check fuel line.
	Air taken in through suction	Check suction line.
	line?
Recoil starter not working	Dust in rotating part?	Clean recoil starter assembly.
properly.	Spring spring failure?	Replace sprial spring.

TABLE 8. MIXER TROUBLESHOOTING

SYMPTOM	POSSIBLE PROBLEM	SOLUTION
	Defective gearbox?	Check that the gears and bearings are not worn . Replace as
		necessary.
Drum rotates rough.
	Worn V-belt?	Replace V-belt.
	Loose pulley?	Tighten or replace pulley.
	Incorrect or no voltage being	Check that the electric motor has the correct supply voltage.
	supplied to electric motor?
	Power to electric motor?	Inspect power source and extension cord. Push reset button on
		electric motor.
		Check level of fuel in fuel tank. Add fuel if necessary. Make sure
Drum does not rotate at all.	Fuel?	fuel is being supplied to the engine. Check to ensure that the fuel
		filter is not clogged.
	Broken V-belt?	Replace V-belt.
	Defective gearbox?	Check that the gears and bearings are not broken. Replace as
		necessary.
	Defective motor?	Replace motor.

MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02) — PAGE 31