MIX N' GO MIXER — INITIAL START-UP (GASOLINE ENGINE)

6.Grasp the starter grip (Figure 25) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

2.Aftertheenginecools,turntheengineON/OFFswitchtothe “OFF” position (Figure 28 ).

Figure 25. Starter Grip

7.If the engine has started, slowly return the choke lever (Figure 23 ) to the CLOSED position. If the engine has not started repeat steps 1 through 6.

8.Before the mixer is placed into operation, run the engine for several minutes. Check for fuel leaks, and noises that would associate with a lose V-belt cover or component.

9.To begin mixing, place the throttle lever (Figure 26) in the "RUN" position

Figure 26. Throttle Lever (Run Position)

Stopping The Engine

Normal Shutdown

1.Move the throttle lever to the IDLE position (Figure 27) and run the engine for three minutes at low speed.

Figure 28. Engine ON/OFF Switch (OFF Position)

3.Closethefuelshut-offvalve(Figure29) bymoving thefuel valve lever to the OFF position.

Figure 29. Fuel Valve Lever (OFF Position)

Emergency Showdown

1.Move the throttle lever quickly to the IDLE position, and turn the engine ON/OFF switch to the OFF position.

Figure 27. Throttle Lever (Idle Position)

PAGE 24 —MIX N' GO MIXER — PARTS & OPERATION MANUAL — REV. #1 (09/09/02)

Page 24
Image 24
Multiquip MC3H, MC3SE operation manual MIX N GO Mixer Initial START-UP Gasoline Engine, Starter Grip