Dynacord H 5000, H 2500 owner manual Mains Switch, H5000

PowerH SERIES

H5000	Umains in V	Imains in A	Pmains in W	Pout in W	Pd in W1	BTU/hr2
Idle	230	0.7	78	-	78	266
Max. Output Power @ 8 Ω3	230	24.5	4089	2 x 1500	1089	3716
Max. Output Power @ 4 Ω3	230	40.9	7137	2 x 2500	2137	7292
1/3 Max. Output Power @ 4 Ω3	230	18.1	2927	2 x 833	1260	4300
1/8 Max. Output Power @ 4 Ω3	230	6.2	877	2 x 313	252	860
1/8 Max. Output Power @ 4 Ω4	230	9.6	1450	2 x 313	806	2750
1/8 Max. Output Power @ 4 Ω4 5	253	11.6	1944	2 x 378	1188	4053
Normal Mode (-10 dB) @ 4 Ω3	230	9.2	1368	2 x 250	868	2962
Rated Output Power (0 dB) @ 4 Ω3	230	37.5	6445	2 x 2100	2245	7660
Alert (Alarm) Mode (-3 dB) @ 4 Ω3	230	22.7	3760	2 x 1050	1660	5664
Max. Output Power @ 2 Ω3	230	44.3	8180	2 x 3500	1180	4026
1/8 Max. Output Power @ 2 Ω3	230	15.3	2427	2 x 438	1552	5296
1/8 Max. Output Power @ 2 Ω4	230	13.6	2105	2 x 438	1230	4197

1.Pd = Power Dissipation

2.1BTU = 1055.06 J = 1055.06 Ws 3.Sine Modulation (1 kHz) 4.Pink-Noise EN60065 / 7. Edition 5.10% Mains Over Voltage

The following factors allow direct proportional calculation of the mains current Imains for different mains supply voltages: 100 V = 2.3, 120 V = 1.9, 220 V = 1.05, 240 V = 0.97.

2.3 Mains Switch

The Mains Switch on the front panel separates the power amp from the mains. Pressing the Mains Switch starts booting up the power amp. A soft start circuit compensates mains inrush current peaks and thus prevents the automatic cutout of the mains from reacting when switching on the power amplifier. Speaker system switch-on is delayed by approximately 2 seconds via output relays, effectively suppressing any possible power-on noise, which otherwise might be heard through the loudspeakers. MUTE-LED light and the fans are running during this delay.

Owner’s Manual 11