PowerH SERIES

3 Operation

3.1 Volume Control

In DUAL and PARALLEL mode, the level controls CH A and CH B on the power amp’s front panel are used to control the amplification of the corresponding channel. Turning the control to the right increases and turning it to the left decreases the volume. In BRIDGED mode operation, the output volume of the power amp is only controlled by the CH A level control. Any changes in the setting of the CH B level control are ignored.

With an installed remote control module, the level controls CH A and CH B may be deactivated, i.e. controlling the power amp’s amplification is only possible via IRIS-Net™. The Level Controls Off ! indicator on the LC display signals that the controls are deactivated.

Illustration 3.1: Level controls CH A and CH B

3.2 Graphical LC display

The graphical LC display provides detailed information about the operating status of the power amplifier. Furthermore, it is possible to change several settings of the power amp and, if installed, of a remote control module.

Illustration 3.2: LC display with controls

1Up / Down buttons: These keys allow navigating through the menu.

2ENTER button: Pressing this key selects the highlighted menu entry.

Owner’s Manual 19

Page 19
Image 19
Dynacord H 5000, H 2500 owner manual Operation Volume Control, Graphical LC display