Dynacord H 2500, H 5000 owner manual H5000

PowerH SERIES

H5000

Amplifier at rated conditions, both channels driven, 8 Ω loads, unless otherwise specified.

Load Impedance	2 Ω		4 Ω	8 Ω
Maximum Midband Output Power	3500 W		2500 W	1500 W
THD = 1%, 1 kHz, Dual Channel
Rated Output Power	-		2100 W	1050 W
THD < 0.1%, 20 Hz...20 kHz
Maximum Single Channel Output Power	4500 W		3200 W	1800 W
Dynamic-Headroom, IHF-A
Maximum Single Channel Output Power	4100 W		2700 W	1600 W
Continuous, 1 kHz
Maximum Bridged Output Power	-		7000 W	5000 W
THD = 1%, 1 kHz
Maximum RMS Voltage Swing			125 V
THD = 1%, 1 kHz
Power Bandwidth			10 Hz...50 kHz
THD = 1%, ref. 1 kHz, half power @ 4 Ω
Voltage Gain, ref. 1 kHz		41 dB / 35 dB / 32 dB (switchable)
Input Sensitivity		0 dBu / +6 dBu / +9 dBu (switchable)
rated power @ 8 Ω, 1 kHz
THD at rated output power		< 0.05%
MBW = 80 kHz, 1 kHz
IMD-SMPTE		< 0.05%
60 Hz, 7 kHz
DIM30		< 0.02%
3.15 kHz, 15 kHz
Maximum Input Level			+22 dBu (9.75 Vrms)
Crosstalk			< -80 dB
ref. 1 kHz, at rated output power
Frequency Response ref. 1 kHz		< 10 Hz...30 kHz (±1 dB)
Input Impedance active balanced			20 kΩ
Damping Factor 1 kHz		> 400
Slew Rate			35 V/μs
Signal to Noise Ratio Amplifier			111 dB
A-weighted, 32 dB constant gain
Output Noise, A-weighted			< -70 dBu
Output Stage Topology		Class H Grounded Bridge (3-stage)
Power Requirements		100-240 V, 50-60 Hz / 100 V, 50-60 Hz
Power Consumption			1450 W
1/8 maximum output power @ 4 Ω
Protection	Audio Limiters, High Temperature, DC, HF, Short Circuit, Back-EMF,
	Peak Current Limiters, Inrush Current Limiters, Turn-on Delay, Mains
	Circuit Breaker Protection, Mains Overvoltage Protection
Cooling		Front-to-Rear, 5-Stage-Fans
Ambient Temperatur Limits		+5 °C...+40 °C (40 °F...105 °F)
Safety Class			I
Dimensions (W x H x D), mm			483 x 88.1 x 497.5
Weight			14.5 kg (32.0 lbs)

Depending on the ambient temperature, the unit might not operate continuously at 2 Ω load in Normal Mode or 4 Ω in Bridged Mode.

136