Miller Electric RCT-224 Trailer manual Assembly, Preparing Unit For Kit Installation, As shown

SECTION 3 − ASSEMBLY

NOTE

This trailer is not compatible with equipment made prior to Serial No. LB033208.

All directions are given as facing the towing vehicle. The word “front” means the hitch end of the trailer.

3-1. Preparing Unit For Kit Installation

Y Stop engine, and let cool.

Disconnect battery negative (−) cable.

Y Do not weld on base. Weld- ing on base can cause fuel tank fire or explosion. Weld only on the four mounting brackets or bolt unit down.

. Go to Section 3-2if mounting

1	brackets are already installed
	as shown.
1	Mounting Bracket
2	3/8-16 x 1 in Screws
	(Supplied)

Remove hardware securing the rear mounting brackets to the base.

	Reverse rear brackets and reattach
	to base with original hardware.
	Tighten hardware to 30 ft lb (41
	N.m).
	2
Tools Needed:
9/16 in	Ref. 190 250-A / Ref. 802 729

OM-6611 Page 6