Miller Electric RCT-224 Trailer manual Installing Taillight And Sidelight Wiring

3-5. Installing Taillight And Sidelight Wiring

Brown And

Green Leads

2

Brown

Lead

Use tab connectors to splice sidelight brown leads to taillight brown leads. Tuck connector through hole in frame.

Brown

Lead

1

Slide clips on frame to secure wiring.

Brown And Yellow Leads

Tools Needed:

802 814

YSupport trailer with jack. Block wheels.

1Wiring Clips

2Grommet

Locate wiring harness (packaged with tail- lights).

Route wiring harness leads through trailer frame and out hole near axle. Slide grommet over leads and install grommet in hole.

Route brown and green leads along axle to-

ward right wheel and brown and yellow leads along axle to left wheel. Secure wiring to axle with supplied cable ties.

Cut 45 in (1143 mm) from brown, green, and yellow leads. Save cutoff wiring for connect- ing side lights. Install taillights and sidelights according to Section 3-10.

To install sidelight wiring: Use 45 in (1143

mm)wiring saved from taillight wiring to wire sidelights. Separate brown leads from green

and yellow leads. Discard green and yellow leads.

Splice sidelight short leads to wiring harness brown leads using supplied tab connector (see Section 3-6). Route brown leads along top of frame and along back of crossmember. Secure leads with wiring clips and cable ties.

Install wiring for other sidelight the same way.

Install sleeving on taillight and harness plug electrical leads.

OM-6611 Page 9