Miller Electric Remote Operator Interface manual Setting Sequence Parameters

SECTION 6 − SETTING SEQUENCE PARAMETERS

6-1. Sequence Parameters In A Program

	Sequence		Parameters
		Volts/Arc	IPM	Seconds
		Adjust
1.	Preflow			Off-5.0
2.	Postflow			Off-5.0
3.	Start	10.0-44.0/	40-1400	Off-5.0
		0-99
4.	Crater	10.0-44.0/	40-1400	Off-5.0
		0-99

.For more information on

Sequence mode, see Feeder Set Up Push Button in Section 5-7.

Weld Time can only be set by using an optional PDA with File Management/WaveWriter software.

If time is set to zero in any timed sequence, the sequence is skipped.

.Maximum IPM may actually be

lower depending on the process and wire type selection.

				Weld
				Crater
				Time
		Start
	Preflow	Time				Postflow
	Time					Time
Preflow		Start	Weld	Crater	Postflow	Sequence
						End
Trigger				Trigger
Pressed				Released

OM-217 834 Page 23