2Unpacking, installing, and setting up the p rinter
2-12
Connecting the power cable
Only use the power cable supplied with the printer!
The laser printer requires a power supply with minimal voltage and
frequency fluctuation. If necessary, ask an electrician for advice.
4Power supply: 120-1 27V at 50- 60Hz / 220- 240V at 50 -60Hz
4Voltage fluctuation: 120V -10%, 127V +6% / 2 20-240V ± 10
4Frequency fluctuation: Wit hin 3 Hz
1Make sure that the printer’s power
switch is in the “0” (OFF) position.
2Insert the plug on the end of the
power cable (supplied) into the
power socket of the printer.
3Insert the other end of the power
cable into a power socket.
CAUTION
Using the wrong power cable may cause a short-circuit!
Using power cables of inadequate cross-section can lead to overheating
of the cable.
ÜOnly use an extension cable which has a higher rating than the current
consumption of the printer.
ÜOnly use cables with a ground connection.
ÜAlways observe the relevant local regulations regarding the
connection of electrical equipment to the main power.