5Control Panel Messages
5-2 CF2001P
Load xx
OHP in tray1 Xx-size overhead projector
transparencies is not loaded
into tray1.
Load xx-size overhead pro-
jector transparencies into
tray1.
Load xx
in any tray Xx-size paper has not been
loaded into any tray. Load xx-size paper into any
tray.
Load xx
Thick 1 in tray1 Xx-size thick 1 is not loaded
into tray1. Load xx-size thick 1 into
tray1.
Near trouble ## / ## Some malfunction occurred
in the printer. Contact your technical repre-
sentative and inform them of
the error code.
No back staples The back staples have run
out. Install new back staples.
No front staples The front staples have run
out. Install new front staples.
No xxxx toner
Call service The toner for the indicated
color is empty. Ask your technical
representative to refill the
toner for the indicated color.
No xxxx toner
Please change The toner for the indicated
color is empty. Refill the toner for the indi-
cated color.
Paper jam at
Jx A paper jam or staple jam
occurred at the indicated
location.
Remove the jammed paper
or the jammed staple. See
page5-16
Power save mode The printer has entered
Energy Saver mode. • To cancel Energy Saver
mode, send a print job, or
open and close a cover.
• To change the time for the
printer to enter Energy
Saver mode, contact a
technical representative.
Printing stopped Paper is loaded into the
manual bypass tray. Remove all paper from the
manual bypass tray.
A communication error
occurred. No action required
Printing suspended Printing has been stopped. No action required.
Replace
Trans. Belt Unit The service life of the
transfer belt unit has expired. Replace the transfer belt
unit.
Service Code
Cxxxx An error occurred. Contact your technical
representative and inform
them of the error code.
Sleep mode The printer has entered
Sleep mode. • To cancel Sleep mod e,
send a print job, or open
and close a cover.
• To change the time for the
printer to enter Sleep
mode, contact a technical
representative.
The guides in tray #
not set right The size of the paper loaded
into tray # is incorrect. Load paper of an appropriate
size into tray #.
Message Cause Action