Mitsubishi Electronics DATA PROJECTOR user manual Connections with Component Signals, E-19

Connecting Personal Computers and Video Equipment

Connections with Component Signals

When the Video Equipment Has a YCbCr Connector or YPbPr Connector

•The projector has been set to “Auto” at the factory; however, if it does not project, please change the input setting to “Compo- nent” using the menu sequence of [Setup] → [Input Format] → [RGB].

See “Input Format” on Page E-53.

•When projecting the YCbCr signal or YPbPr signal, if the color of the overall image strongly leans toward being greenish or another color, change the setting under the menu of [Color] → [Color Space].

See “Color Space” on Page E-47.

Note:

*When the input format has been switched, you may be required to reconnect the input signal.

*In some rare cases, the picture may not be displayed, depending on the connected device.

Component cable (Not supplied)

Green

Blue

Red

Y Cb Cr

COMPONENT

COMPONENT

Y Pb Pr

Green

Blue

Red

Component cable (Not supplied)

Projecting component signals

Please note that when inputting 480i or 576i signals using a separately sold component cable and viewing video images, depending on the connected device and the video source being projected, the picture may be disturbed or may not be projected properly.

In such cases, it is possible to achieve a picture with no disturbance that is projected properly by either switching to 480p signals or connecting using an S-Video cable instead.

E-19