General Operation
Using the Laser Pointer
The remote control unit’s laser pointer can be used to point to the section currently being explained, making presenta- tions more effective.
CAUTION
Do not look at the laser pointer’s light source. |
|
| |
Be sure to heed the following. Pointing the laser beam at | This label is located on the side of the remote control. | ||
the eyes could lead to reduced vision or vision impairment. | |||
|
| ||
•Never look at the laser pointer’s light source.
•Do not point the laser beam at people.
•Do not let children use the laser pointer.
Operation
The red laser beam is emitted from the tip of the remote control unit while the LASER button is pressed in. Point the remote con- trol unit’s transmitter in the direction you want to indicate.
The laser beam turns off when you release your finger from the
LASER button.
3
| FREEZE | ||
1 |
|
| |
VOL | ZOO | 2 | |
4 | M | ||
| |||
ENTER MUTE
TIME R
| STAN |
| ||
| RGB | DBY |
| |
MENU | EO | LASER | ||
VID | ||||
| QU | AUTO | ||
| Q | ICK |
| |
R- |
|
|
| |
CANCELCLICK/ |
|
|
| |
LASER
Note:
If a button on the remote control unit is held in continuously for approximately 30 seconds, signal transfer will be suspended. To resume transferring signals, press the button again.
Also, to use the jog button after signal transfer has been suspended, first press any other button, then press the jog button.
