Gigabit 8-Port Workgroup Switch
The Back Panel
The ports are located on the back panel of the Switch.
Figure 2-2: Back Panel
Ports
10/100/1000
ETHERNET 1-8 The Switch is equipped with eight auto-sensing, Ethernet network ports, which use RJ-45 connectors. These ports support auto MDI/MDIX cable detection and network speeds of 10Mbps, 100Mbps, and 1000Mbps. They can operate in half and full-duplex modes. Auto- sensing technology enables each port to automatically detect the speed of the device connected to it (10Mbps, 100Mbps, or 1000Mbps), and adjust its speed and duplex accordingly.
Power | The Power port is where you will connect the included power adapter. |
NOTE: If you need to reset the Switch, unplug the power adapter from the back of the Switch. Wait a few seconds and then reconnect it.
Chapter 2: Getting to Know the Switch | 4 |
