Preparating your projector

Checking accessories

The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.

Cables

Mini D-SUB

 

 

15-pin

D-SUB 9-pin

 

 

 

 

 

Mini D-SUB

8-pin

 

 

15-pin

 

 

 

Audio/Video cable

S-video cable

RGB cable for PC

RS-232C cable

(246C478-10)

(246C479-10)

(246C521-10)

(246C508-10)

 

 

 

• Used for adjustment by

 

 

 

service person.

Power supply parts

Power cord (two)

(246C483-10, 246C383-20)

Remote control parts

Remote control

R6 (Size-AA)

(290P128-10)

battery (two)

Others

Lens cap (Attached to the projector)

User manual (871D423-10)

Quick Start up (857D064-20)

Important:

The attached power cords are to be used exclusively for this product. Never use them for other products.

 

Inserting the batteries into the remote

1

control

1. Remove the rear lid of the remote control.

3

2. Check the polarity (+), (-) of the batteries, and set them

 

correctly, inserting their (-) side first.

 

• If the battery is inserted from the (+) side first,

2

inserting the (-) side is difficult because the coil spring

end hits on the battery side. If the battery is forced to

 

insert in this way, the outer label of the battery may

 

get ripped and it may cause a short-circuit and heat-

 

ing.

 

3. Attach the rear lid.

Important:

Use two size-AA batteries (R6).

Replace the two batteries with new ones when the remote control is slow to operate.

CAUTION

Use of a battery of wrong type may cause explosion.

Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

Dispose of used batteries according to your local regulations.

Batteries may explode if misused. Do not recharge, disassemble, or dispose of in fire.

Be sure to handle the battery according to the instructions.

Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

Keep batteries out of reach of children and pets.

Remove the battery, if the remote control is not used for a long time.

Do not combine a new battery with an old one.

If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

EN-6

Page 6
Image 6
Mitsubishi Electronics HC900 Preparating your projector, Checking accessories, Inserting the batteries into the remote