Advanced features (continued)
Installation other device’s remote commands
You can install other device’s remote commands in the remote control of this projector.
How to install
1.Set the SELECT switch of the remote control of this projector to DVD or VIDEO, depending on the device you use.
2.Place the remote control of this projector and that of the other device with their transmission windows
2 - 5cm
Programmable buttons
MEMORY button
SELECT switch
3.Press the MEMORY button.
•The MEMORY button will blink red.
•To cancel the installation, press the MEMORY button again.
4.Press any programmable button on the remote control of this projector.
•The MEMORY button will stop blinking and stay on.
•When no button is pressed for 6 seconds after step 3 and 4, the MEMORY button will go out automatically.
5.Hold down the button on the other device’s remote control whose command you want to install until the MEMORY button start blinking.
•When the MEMORY button blinks six times and then goes out, the function has been installed successfully.
•When the MEMORY button doesn’t blink before going out, the installation has failed.
•To continue to install other functions, repeat step 3 to 5.
•Some special commands are not memorized, depending on the type of the remote control.
•Do not install any remote commands of other devices including air conditioners than video devices.
How to use the installed functions
1.Set the SELECT switch of the remote control of this projector to DVD or VIDEO, depending on the device you use.
2.Press the programmable button in which the desired remote command has been installed.
