Mitsubishi Electronics HC910 user manual C. Projecting images, EN-15, Preparation, English

C. Projecting images

Preparation:

•Remove the lens cap.

•Turn on the power of the connected video equipment.

FOCUS ring
	COMPONENT button
ZOOM ring	ON ( I ) button
	VIDEO button
	S-VIDEO button
POWER button	POWER STATUS

VIDEO button

1.Confirm the POWER indicator lights up red.

•If the projector was turned off before the lamp was cooled down sufficiently last time, the fan may start rotating and the POWER button may not work after the power cord is plugged. (The STATUS indicator blinks green.) After the fan stops rotating, press the POWER button to turn back on the POWER indicator.

2.Press the POWER button on the projector or ON ( I ) button on the remote control.

•It may take about one minute for the lamp to light up.

•The lamp fails to light up on rare occasions. In such a case, wait for a few minutes and then try again.

•Do not cover the lens with the lens cap while the lamp is on. Do not strip off the aluminium sheet inside the lens cap.

•The STANDARD lamp mode is activated by default whenever the projector is turned on. When the LOW lamp mode has been chosen, the default STANDARD lamp mode is switched to the LOW lamp mode in 1 minute.

3.Select an input source.

•Press the VIDEO button on the projector or the VIDEO, S-VIDEO or COMPONENT button on the remote control that is corresponding to the terminal in use.

•The input source is switched between VIDEO, S-VIDEO and COMPONENT at every press of the VIDEO button on the projector.

•Though it may take some time before an image is displayed on the screen depending on the type of the input signal, such symptom is not a malfunction.

•Some images become easier to view when the setting of aspect ratio is changed. (See Page 17.)

4.Adjust the position of the projector to keep an appropriate projection distance with which images are projected in their specified sizes.

5.Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See Page 10.)

•When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See Page 10.)

6.Adjust the size of the projected image by turning the ZOOM ring.

7.Adjust the focus by turning the FOCUS ring.

Repeat steps 4 to 7, if necessary.

ENGLISH

EN-15