Mitsubishi Electronics LT-2220/LT-3020 manual Connecting a DTV Receiver

Connecting a DTV Receiver

Note: The TV side panel and connections shown here are for reference only and may vary by model.

See Appendix B, page 58 for component video signal compatibility information.

For digital audio connections, see your DTV receiver and A/V receiver Owner’s Guides.

DTV Receiver with Component Video Connections (Recommended)

(Figure 11)

1.Connect the outside antenna cable, or satellite to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver owner’s guide for instructions and cable compatibility).

2.If your DTV receiver has a built-in terrestrial tuner, connect the incoming terrestrial antenna to ANT on the DTV receiver. If your DTV receiver does not have a built-in terrestrial tuner, this TV will only be able to provide an analog signal through ANT on the TV side panel.

3.Connect the RCA-type cables from the DTV receiver outputs to the TV side panel. Component (1 or 2) may be used for 480i, 480p, 720p or 1080i components.

4.Connect the L (left) and R (right) audio cables from the DTV receiver to DTV AUDIO on the TV back panel.

5.To utilize the benefits of a digital A/V receiver, connect your DTV receiver’s digital audio out to a digital input on your digital A/V receiver.

�� ���� ����� � �����

��� �

����� �

�

�

�

��������

��������

�� ������

�

				�
��� �������� ����� ��������� ����� ������������
								�������
							���� �� ���������� �����
		�����	�����		�����			�� ��� ����
�	�	�	�	�
				��������		��� �� ��
�				�		�� �
	��	�	�			�� �
					���	�������
��						����� ���
�	��
		� ����	� ����
����� ���� ������				�������		�� ���� ���		��������� ��
							��
							�	�� ��������
								����� �� ���������
								�

Figure 11. Connecting the DTV receiver with component Video Connections.

19

LCD Monitor 5 8 03.indd 19

5/8/2003, 3:02 PM