Mitsubishi Electronics LT-52153, LT-40153 A/V Receiver with HDMI Output, 22 2. TV Connections

222. TV Connections

A/V Receiver

Most setups require either a digital audio cable or analog stereo audio cables. To send audio from TV channels received on the ANT input or devices con- nected directly to the TV, you must use one of the connections shown below. Usually, only one of these connections is required.

The TV makes all audio available in digital and analog formats:

•Analog audio coming into the TV is available as output in digital stereo format on the DIGITAL AUDIO OUTPUT jack.

•Digital incoming audio is available as analog output on the AVR AUDIO OUTPUT L and R jacks.

AVR AUDIO OUTPUT

R L

TV

Stereo analog cables (for an analog A/V receiver)

or

Digital coaxial cable (for a digita A/V receiver)

OPTICAL

INPUT

COAXIAL

INPUT

A/V receiver back panel

A/V Receiver with HDMI Output

Required: One HDMI-to-HDMI cable

This option allows you to view content from devices connected to an A/V receiver over a single HDMI cable going to the TV. The HDMI cable can transmit both audio and video to the TV.

You can use an HDMI connection as described here in addition to an audio connection from the TV’s audio output. The optional audio connection allows you to hear, through the A/V receiver, devices connected to the TV only, e.g., an antenna on the ANT input.

You may be able to use the TV’s remote control (in TV mode) to operate connected CEC-enabled HDMI devices. Experiment with your equipment to determine which functions are available to the TV’s remote control. See Appendix C, page 74.

153 Series: This setup allows you to use NetCom- mand-controlled audio and video switching over the HDMI cable. See “Case 3: Automatic Audio and Video Switching via HDMI” on page 62.

To use NetCommand to supplement HDMI control of a CEC-enabled A/V receiver, note the recommendations under “More About Using an HDMI Connection,” page 62.

AVR AUDIO OUTPUT

R L

TV

Optional

HDMI cableanalog or digital audio connection

Note:

•On rare occasions, an HDMI signal may be copy-restricted and cannot be output from the TV as a digital signal. To hear these copy- protected signals through the A/V receiver, use the connection for an analog A/V receiver.

•Check the A/V receiver’s Owner’s Guide for information concerning use of the digital input and switching between digital sound and analog stereo sound from the TV.

A/V receiver with	HDMI OUT	L R
		ANALOG AUDIO IN
HDMI output

Any connection types

High-definition

DVD player

Cable box

DIGITAL

AUDIO IN

VCR

DVD player