Mitsubishi Electronics LT-52151, LT-40153 manual Setting Up A/V Receiver Control, Power and Volume

6. NetCommand Control of an A/V Receiver 59

Setting Up A/V Receiver Control

Power and Volume

Perform this setup to control the A/V receiver power and volume with the TV’s remote control.

To perform this setup you need:

•The remote controls for both the TV and the A/V receiver.

•An IR emitter cable available from Mitsubishi.

Before You Begin

1.Connect your A/V receiver to the TV and any addi- tional devices. See “Setting Up TV Inputs,” page 12 and “TV Connections,” page 16.

2.Connect the IR emitter cable to the TV and position the IR emitter where it can send signals to the A/V receiver. See “IR Emitter Placement,” page 53.

3.Set the TV’s remote control to TV mode using the side button.

Setup to Control A/V Receiver Power and Volume

1.Open the Inputs > AVR screen in one of two ways:

•If using the New Device Found screen for the A/V receiver, highlight NetCommand and press ENTER to open the AVR screen.

•If performing NetCommand setup at any time after Auto Sensing:

Press MENU, highlight Inputs, and highlight AVR to open the AVR menu.

2.The first function highlighted in the AVR screen is always Power. Aim the TV’s remote control at the TV and press ENTER to begin learning for Power.

IMPORTANT

To hear audio sent from the TV to the A/V receiver, you must have:

•Physically connected the TV to the A/V receiver via the analog or digital audio output.

•Assigned, if needed, the name AVR if using an HDMI A/V receiver.

•“Learned” the IR codes for the A/V receiver inputs.

•Assigned the TV’s audio output to the correct input in the NetCommand Inputs > AVR menu.

•Selected the A/V receiver as the audio source.

Press MORE then 9 (AUDIO), then to show the Speakers option, then to select the A/V Receiver.

Inputs > AVR screen. Perform NetCommand IR “learning” for A/V receiver power and volume keys.

3.When the Power text starts flashing, aim the A/V receiver’s remote control at the TV and hold the POWER or POWER ON key until a check mark appears next to Power.

•If the text stops flashing before the check mark appears, repeat this step.

•To remove the key from NetCommand control, press the CANCEL key while the key name is highlighted.

4.Press the key on the TV’s remote control to highlight other keys in the list. Repeat steps 2 and 3 for each addi- tional function you wish to control through NetCommand.

5.If the A/V receiver has a separate POWER OFF key,

press on the TV’s remote to highlight Power Off. Repeat steps 2 and 3 to “learn” the POWER OFF key.

If the device has no POWER OFF key, skip this step.

6.When finished “learning” the power and volume keys, either

•To watch TV, press bACK .

•To continue with NetCommand setup to control switching of A/V receiver inputs, highlight

NEXT and press ENTER.